As a wedding photographer Sydney you probably have asked the question, how do I avoid flash blow out in my pictures? You are not alone as regards this challenge and it is a very frustrating one at that. Flipping through pictures on Flickr I realize this is one of the most common frustrations of photographers, especially with those using point and shoot cameras.
With these sort of cameras, you have very little control over the intensity and direction of the flash. As much as this can be a problem, there is a solution for it. First, let me share what an experienced photographer told me. Your flashlight is a secondary source of light and must be treated as such. There is always going to be ambient light when shooting so your flashlight should augment this instead of trying to overcome it.
Here are a few tricks to help you avoid a flash blow out as a wedding photographer Surrey.
Don’t be too close to your subject
Most of the time, why there is a flash blow out is because you are too close to the subject when you have no control over the direction and intensity of the flash. Stepping back a little distance would cancel out this effect conveniently. I know you are advised to fill the frame while taking pictures so you feel you need to be very close to the subject. You can still achieve the filling effect without being too close. Try zooming in, but you have to careful not to shake the camera. You can also crop the photos after taking the shot.
Diffusing the light from your flash
Photographers using dedicated flash units can achieve this very easily but when you are using a point and shoot camera, you might need to be a bit more creative with your methods. One of such hacks will be to cover your flash with a semi-opaque material. The impact of this on the photo is that the color of the material will determine the color of the resulting flash and thus the color balance of the photo. Your best bet is white paper tape.
Redirect the light
Again, with a dedicated flash unit, this is easily achievable but with a point and kill, you need to improvise. The whole idea is to redirect the light coming from your flash or just bounce it off a certain surface to help reduce the intensity. Since you cannot change the direction of your flash points on your point and shoot camera, you need to use a hack. So many photographers in your shoes have opted for a piece of card set at an angle in front of the flash. This way the light is directed upwards or to some other direction to get better pictures. You should also know that the color of the card will impact the color cast on the shot. To get perfect at this you need a lot of time to practice.
Reduce flash output
You can check your camera manual to see if you have this feature which lets you decrease the flash output. If you do then you can simply dial down on the intensity of the flash output. You need to practice this severally to see how best it will work for your pictures in different situations.
I hope the above tricks have been helpful for you? With these tricks, life as a wedding photographer Sydney just like www.yasminanadine.com should be easier since you can now take pictures without being scared of a flash blow out.